Flat Roof Drain Placements – Watch Video

Types of Drainage Systems

Factors to Consider

• Drain and pipe must be significant enough for any volume of water.

• The roof should slope toward the drain.

• A drain strainer must be designed to allow small debris and water to flow freely to the drain.

• The placement of the drain, to other rooftop units, should be carefully determined.

Flat Roof Drain Basin – Video

A basin is a lowered area, recessed into a flat roof’s substrate, where water converges and drains, even when there is an accumulation of debris.

https://youtu.be/40OynPJ2svY

When Drain Basins are Needed

The images show drains that are correct at the lowest part of the roof. The problem is, however, that an accumulation of debris is preventing water from draining. If these roofs had drain basins, water could have flowed over the debris.

When the Location, Basin, and Strainer Work Together… 

…this image shows an example of a drain that functions as a proper drainage system on a commercial flat roof.

Inner Drains –

Although drains are on a flat roof’s surface, the inner drain pipes exist on the inside of the building, and below the ground surface leading to a drainage system. This prevents the pipes from freezing during the extreme temperatures of winter.

Scuppers –

Scuppers are openings in parapet walls, of commercial flat roofs, from which water can drain. These are very effective since water will flow freely through them, to a dedicated controlled area.

Outer Drains –

Outer drains begin on a commercial flat roof surface that is attached to drain pipes, which lead down the outer wall of a building, to the ground surface. During extreme winter weather conditions, water in these leader pipes, can freeze and crack the pipes.

Gutters – 

Gutters are a type of drainage system that is used to divert water from a roof and away from a building’s walls and foundation. In extreme winter weather conditions, water tends to freeze causing a build-up of ice, in the troughs, which prevents drainage.

This flat roof slopes toward the center of the roof where the drain is, however, the installation of a basin would have prevented ponding water and the growth of plant life.

A Cast Iron Basin Drain from the 1930s

This cast iron drain and strainer is from the 1930s. Notice the small “basin” around the strainer. This basin was a good idea, but could not handle the amount of debris accumulation, and the strainer holes and slots were too small and narrow.